Installing the #0-80 bolts in BVM Jet Wheels

Follow this procedure after drilling the holes.  It really makes this formally tedious task very easy.

  Insert a 2" X .047" wire into a pin vise then sharpen the end.  Use a Propane torch to heat about 1/2" of the pointed end to red hot.

  Push it through the black side of the aluminum rim until it easily protrudes through the front side of the rim.  Repeat from the otherside.

 

Note:  You will need to replace the wire occasionally due to effects of the heating process.

 


click on image to enlarge


 It is handy to use a small hammer to tap the screws through the rubber, then make final engagement into the threads with the small screw driver.

 

Contact Us
All graphics, photos and text Copyright 2014 BVM, Inc.
Use of graphics or photos without written permission from BVM is strictly prohibited.